`timescale 1ns/1ps // ECE 287 - Exercise 3 testbench: does "done" happen once a second? // Paste this into the LEFT pane (testbench.sv) on EDA Playground. // // Here "one second" is shrunk to MAX_COUNT = 10 clocks so you can read // every line of the log. // // In EPWave (it opens empty): Get Signals -> scope tb -> select clk, start, // done; then scope tb.dut -> select count -> Append Selected. Count the clock // periods between start rising and done rising. // // Questions to answer from the log: // 1. How many clocks after start goes high does done go high? // 2. While start stays high, does done ever go back to 0? // 3. For the challenge you need something that happens ONCE EVERY // second, over and over. Does this counter do that as written? // What would have to change, here or in how you drive start? module tb; localparam MAX_COUNT = 10; reg clk = 1'b0; reg rst = 1'b0; reg start = 1'b0; wire done; integer cyc; integer rises; integer falls; reg last_done; counter_50MHz #(.MAX_COUNT(MAX_COUNT)) dut(.clk(clk), .rst(rst), .start(start), .done(done)); // From Exercises 1 and 2, not instantiated here. design.sv still has both // modules; the instances stay commented out until the challenge. // lfsr dut_lfsr(.clk(clk), .rst(rst), .seed(seed), .en_seed(en_seed), .number(number)); // seven_segment dut_seg(.i(i), .o(o)); always #10 clk = ~clk; // 50 MHz initial begin $dumpfile("dump.vcd"); $dumpvars(0, tb); repeat (3) @(posedge clk); #1 rst = 1'b1; repeat (3) @(posedge clk); #1 start = 1'b1; rises = 0; falls = 0; last_done = done; $display("start went high. MAX_COUNT = %0d", MAX_COUNT); $display(" clock | count | done"); for (cyc = 1; cyc <= 4 * MAX_COUNT; cyc = cyc + 1) begin @(posedge clk); #1; $display(" %3d | %3d | %b", cyc, dut.count, done); if (done == 1'b1 && last_done == 1'b0) rises = rises + 1; if (done == 1'b0 && last_done == 1'b1) falls = falls + 1; last_done = done; end $display(""); $display("In %0d clocks (about %0d 'seconds'), done went 0->1 %0d time(s) and 1->0 %0d time(s).", 4 * MAX_COUNT, 4, rises, falls); $finish; end endmodule