`timescale 1ns/1ps // ECE 287 - Simple Sequential Design // Exercise 3: the one-second counter from the slides. // Paste this into the RIGHT pane (design.sv) on EDA Playground. // // This file builds up the big design one piece at a time. Modules from // earlier exercises are kept here, complete, but nothing instantiates them // yet (their instantiations are commented out in testbench.sv). In the // challenge, your top level instantiates all of them. // --------------------------------------------------------------------------- // From Exercise 1: LFSR (not instantiated in this exercise) // --------------------------------------------------------------------------- module lfsr( input clk, input rst, input [7:0]seed, input en_seed, output reg [7:0]number); always @(posedge clk or negedge rst) begin if (rst == 1'b0) begin number <= 8'd0; end else begin if (en_seed == 1'b1) number <= seed; else number <= {number[6], number[5]^number[4], number[4], number[3], number[2], number[1], number[0], number[7]^number[2]}; end end endmodule // --------------------------------------------------------------------------- // From Exercise 2: seven-segment decoder (not instantiated in this exercise) // --------------------------------------------------------------------------- module seven_segment( input wire[3:0]i, output reg[6:0]o ); always @(*) begin case (i) // 6543210 4'h0: o = 7'b1000000; 4'h1: o = 7'b1111001; 4'h2: o = 7'b0100100; 4'h3: o = 7'b0110000; 4'h4: o = 7'b0011001; 4'h5: o = 7'b0010010; 4'h6: o = 7'b0000010; 4'h7: o = 7'b1111000; 4'h8: o = 7'b0000000; 4'h9: o = 7'b0010000; 4'ha: o = 7'b0001000; 4'hb: o = 7'b0000011; 4'hc: o = 7'b1000110; 4'hd: o = 7'b0100001; 4'he: o = 7'b0000110; 4'hf: o = 7'b0001110; endcase end endmodule // --------------------------------------------------------------------------- // NEW in Exercise 3: one-second counter // // One change from the slide: the 50,000,000 limit is now a parameter, // MAX_COUNT, so a testbench can shrink "one second" to a few clocks. // Simulating 50 million clocks would take far too long. // // Question: on the slide the comparison was written as count >= 7'd50000000. // How many bits does 50,000,000 need? What would 7'd do to it? // --------------------------------------------------------------------------- module counter_50MHz #(parameter MAX_COUNT = 50000000) (input clk, input rst, input start, output reg done); reg [26:0]count; always @(posedge clk or negedge rst) begin if (rst == 1'b0) begin count <= 27'd0; done <= 1'b0; end else begin if (start == 1'b0) count <= 27'd0; else count <= count + 1'b1; if (count == 7'd0) done <= 1'b0; else if (count >= MAX_COUNT) done <= 1'b1; end end endmodule