`timescale 1ns/1ps // ECE 287 - Exercise 1 testbench: watch the LFSR. // Paste this into the LEFT pane (testbench.sv) on EDA Playground. // // Things to try (edit and re-run): // 1. Change SEED below. Does the sequence change? Does the period change? // 2. Set USE_SEED to 0 so the seed is never loaded. What happens, and why? // // In EPWave (it opens empty): Get Signals -> scope tb -> select clk, rst, // en_seed, number -> Append Selected. Find the clock edge where number // becomes the seed. module tb; localparam [7:0] SEED = 8'hA5; // try other values localparam USE_SEED = 1; // 1 = load SEED after reset, 0 = never load it reg clk = 1'b0; reg rst = 1'b0; // active low, like KEY[2] on the board reg [7:0] seed = SEED; reg en_seed = 1'b0; wire [7:0] number; integer i; integer period; reg [7:0] first; lfsr dut(.clk(clk), .rst(rst), .seed(seed), .en_seed(en_seed), .number(number)); always #10 clk = ~clk; // 20 ns period = 50 MHz, like CLOCK_50 initial begin $dumpfile("dump.vcd"); $dumpvars(0, tb); // hold reset for a few clocks, then release it repeat (3) @(posedge clk); #1 rst = 1'b1; // optionally load the seed for one clock if (USE_SEED) begin #1 en_seed = 1'b1; @(posedge clk); #1 en_seed = 1'b0; end $display("seed loaded: %0d (USE_SEED = %0d)", (USE_SEED ? SEED : 0), USE_SEED); $display(" clock | number (dec) | number (bin)"); // print the first 20 values for (i = 0; i < 20; i = i + 1) begin @(posedge clk); #1 $display(" %3d | %3d | %b", i, number, number); end // how many clocks until the sequence comes back to the same value? first = number; period = 0; for (i = 0; i < 300; i = i + 1) begin @(posedge clk); #1 period = period + 1; if (number == first && period > 0) i = 300; // found it, stop looking end if (number == first) $display("The value %0d came back after %0d clocks.", first, period); else $display("The value %0d did not come back within 300 clocks.", first); $finish; end endmodule